Gooseneck design Ratchet
Loaded 5th wheel height 50"
Swing radius 108"
Support cylinder Hydraulically operated
Power source Hydraulic couplings: 3/4" fixed at front with piping for wet line
Gooseneck locks Ratchet
Electrical receptacle Seven pin connector
Deck section design Four beam
26'-6" (26'-0" clear) without removable rear ramp
24'-6" (24'-0" clear) with rear deck ramp in place
Deck section length
Deck section width 8'-6"
Loaded road clearance 6"
Loaded deck height 20"
Flooring 1-1/2" apitong secured with deck screws; no lumber between main beams
Mainbeams 14" T-1A
Gooseneck/deck connection Horizontal pin and plate with remote lock
Deck/rear bridge connection Fixed/welded
Outriggers 12" swinging/removable with double hook-on at front of deck
Slope front of deck top down With smooth plate & traction bars
Slope front of deck bottom up 8-3/4" finished main beam height
50" wood filled with offset hinge, short hinge length, ramp to slide in only - not past the side members
Heavy duty front folding ramps
Expanded metal Between main beams 1st deck section at front and last deck section at rear
Bucket well, recess last 4 deck cross members in deck between main beams
and cover with 1/4" plate
3. REAR BRIDGE
Loaded rear bridge height 41"
Rear bridge section width 8'-6"
Number of axles 3
Axle capacity 25,000# - GAWR 24,700#
Axle spacing 54"
Brakes 16-1/2" x 7" air actuated with spring brakes on one axle
Anti-lock brake system None required - GVWR is greater than 120,000#
Ten (10) stud; 285.75mm BC aluminum/steel disc hub piloted system with oil
seals, inner wheels steel with outer aluminum wheels polished
Wheels
Tires Twelve (12) 275/70R22.5 (H) 16PR radials
Suspension Ridewell air
Air Lift third axle
Exhaust Valve Manual
Manual raising & lowering (+3"/-3")
Air Weigh Bluetooth Digital Scale
Rear Bridge Center Section Boom well, cross members recessed - recess 1st member additionally
Wide center bolster With chain slots & flag holder slots
Rear half bolster Rear of axle 3 with flag holder slots
Front bridge ramp Sloped to deck outboard of main beams with plate and traction bars
Fenders 1/4" floor plate over tires only
Connections for future removable axle Rear of axle 3, includes ears and air/electrical connections
1) Omit 1st cross member in rear bridge section (shock mount cross member)
2) Removable wood filled paver transition ramps outside main beams, NO ramp between main beams - decreases deck length (See deck length above)
3) Roller stops each side at rear of axle 3
Additional rear bridge specifications
4. GENERAL
12 volt LED system including mid-turn lights, license plate light regular
1) 2 strobe lights at rear with switch
2) Battery pack with switch to flash strobes and lights when gooseneck is
disconnected
